# Interposer frameless r5b (item 7, run q_run_20261028)
r5a geometry imported unchanged (body, pins, clips), plus:
- Hollowing/infill: 15 internal cells (3 columns x 5, each 5.31 x 7.92 x 6.5) between the pin columns. Ribs 1.6 (the internal infill), skins 1.6 top / 3.7 bottom, 1.6 web to the pin guides. Volume 23.3 cm³ vs 27.3 (about -15%).
- Vents: 30 x Ø1.2, two per cell, open on the PCB face. They sit on the vat side in the print orientation, so they drain and can be IPA-flushed. Unvented cups: none.
- Supports (modeled, STEP group print_supports, plus *_print_supported.stl/.3mf): 126 cones (tip Ø0.4, base Ø1.2, 5 mm lift) on the TOP face only, 2 mm raft.
- Print orientation: top face toward the plate. The clips print last, pointing away from the plate, with no support marks on the barbs, ramps or tips. The barb ledge is a 0.5 mm ring overhang and is self-supporting.
Checks (verify_interposer_r5b.json): 1 solid. Min web 1.453, min wall 1.6 (rule 1.45) OK. Snap checks are identical to r5 (undercut 0.40, ledge 1.65, tine clearance 0.10, tip 1.6). The clip geometry is unchanged, so the r5 clip strain values stay valid.
Sand the top-face support nubs to under 0.1 mm: the stack has a 0.2 gap to the next board.
Nothing ordered.

## 2026-10-28 decision (the designer)
The 30 Ø1.2 vents stay on the PCB face (confirmed). No geometry change.
